Datalogic Gryphon I GFE4500, Product Reference Manual

Page: 241 / 312

KEYBOARD INTERFACE
PRODUCT REFERENCE GUIDE
227
Intercode Delay
Specifies the delay between labels transmitted to the host for this interface. The select -
able range for this feature is from 0 to 99 seconds.
Follow these instructions to set this feature:
1. Determine the desired setting.
2. Pad the number with leading zeroes to yield two digits. For example: 0 = 00, 5 =
05, 20 = 20, etc
3. Go to
page 56
and scan the ENTER/EXIT PROGRAMMING MODE bar code to enter
Programming Mode.
4. Scan the bar code: SELECT INTERCODE DELAY SETTING on
page 56
.
5. Scan the appropriate two digits from the keypad in
Appendix E
, that represent the
duration which was determined in the steps above. You will hear a two-beep indi -
cation after the last character.
6. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit Programming Mode.
This completes the procedure. See the table below for examples of how to set this fea -
ture.
Table 11 - Intercode Delay Setting Examples
NOTE: If you make a mistake before the last character, scan the CANCEL
bar code to abort and not save the entry string. You can then start again at
the beginning.
STEP
ACTION EXAMPLES
1 Desired Setting No Delay 5 seconds 60 seconds 99 seconds
2 Pad with leading zero(es)
00 05 60 99
3 Scan ENTER/EXIT PROGRAMMING MODE
4 Scan SELECT INTERCODE DELAY SETTING
5
Scan two characters from
Appendix E
‘0’ and ‘0’ ‘0’ and ‘5’ ‘6’ and ‘0’ ‘9’ and ‘9’
6 Scan ENTER/EXIT PROGRAMMING MODE