DKG-119J User Manual V-32
(09.07.2012)
- 2 -
Section
1. INSTALLATION
1.1. Introduction to the Control Panel
1.2. Mounting the Unit
1.3. Wiring the Unit
2. INPUTS AND OUTPUTS
3. DISPLAYS
3.1. Led Displays
3.2. Language Selection
3.3. Digital Display
4. ALARMS AND WARNINGS
5. MODES OF OPERATION
6. OTHER FEATURES
6.1. Remote start operation
6.2. Sender type selection
6.3. Engine heating operation
6.4. Engine Idle Speed Operation
6.5. Engine Block Heater
6.6. Fuel Pump Control
6.7. Mains Simulation (Disable Start)
6.8. Delayed Mains Simulation, Battery Charging
6.9. Dual Genset Mutual Standby Operation
6.10. Periodic Service Request Monitoring
6.11. Engine Hours Meter
6.12. Display of Software Version
6.13. SMS message sending
6.14. Remote Monitoring and Programming
6.15. External Control of the Unit
6.16. Resuming to factory set parameters
6.17. Gas engine fuel solenoid control
6.18. Load Shedding / Dummy Load
6.19. Fuel Theft / Fuelling Messages
6.20. Firmware Update
6.21. Changing the Default Engine Speed in Volvo Engines
6.22. Engine Control Mode
6.23. Dual Voltage and Frequency
6.24. Single Phase Operation
7. J1939 ENGINE MONITORING AND CONTROL PORT
8. MODBUS COMMUNICATION
9. EVENT LOGGING
10. STATISTICAL COUNTERS
11. MAINTENANCE
12. PROGRAMMING
13. TROUBLESHOOTING
14. DECLARATION OF CONFORMITY
15. TECHNICAL SPECIFICATIONS
16. CONNECTION DIAGRAM
TABLE OF CONTENTS
