DM4170 – Installation Manual
Installing the DM4170
204.4308.03
28
R
EMOVING
SFP/SFP+
M
ODULES
Before removing the optical cords, it is recommended that you check if there are
labels on them that indicate to which equipment and port they should be
connected, facilitating their identification later.
In order to remove the modules, simply follow the same insertion instructions in reverse
order:
Step 1
•
Remove the optical cords.
Step 2
•
Lower the safety latch.
Step 3
•
Pull the module by its safety latch, as shown in the figure below.
Figure 24 – Removing the SFP/SFP+ from the cage
Table 17 – Removing a SFP/SFP+ module
When operating at temperatures over 45°C, the user must monitor the operating
temperature of the optical modules. Contact
questions.
