Data Translation DT3145, Getting Started Manual

Page: 39 / 60

Connecting Signals
31
4
4
4
4
4
4
4
4
4
Notes: In Figure 6 , IN refers to digital input signals, OUT refers to
digital output signals, DGND/TRIGGER refers to the external
trigger input signal, STROBE refers to the strobe output signal,
DGND refers to digital ground signals, and +5 V refers to a +5 V
(250 mA) output signal from the DT3145 board.
The dark filled circles in Figure 6 represent holes that you can use to
mount the STP15 on a DIN rail. To mount the STP15 on a DIN rail,
you need two DIN rail mount adapters (Phoenix Contact part
number 1201578 or Data Translation part number 18083), and four
thread form screws (Bossard part number BN2724M3x8 or Data
Translation part number 18193).
If you are connecting an external trigger input signal, make sure that
you have configured the trigger selection jumper to specify whether
the trigger input is a common-ground isolated signal or a TTL-level
input signal. For more information, refer to
page 18 .
Once you have connected the appropriate signals to the STP15 screw
terminal panel, apply power to the camera and the computer, then
verify the operation of the board using the DT-AcquireCL
example
program. Refer to Chapter 5 starting on page 33 .