Data Translation DT3145, Getting Started Manual

Page: 37 / 60

Connecting Signals
29
4
4
4
4
4
4
4
4
4
Connecting Signals to Connector J2
Note: This section assumes that you have purchased an optional
STP15 screw terminal panel; the EP337 cable is shipped with the
STP15.
To connect digital input, digital output, external trigger input, strobe
output, and/or +5 V output signals to connector J2 on the DT3145
board, perform the following steps:
1. Make sure that power to the computer is off.
2. Push one end of the EP337 cable into the J2 connector on the
DT3145 board, and tighten the screws on the connector.
3. Push the other end of the EP337 cable into the STP15 screw
terminal panel, and tighten the screws on the connector. Refer to
Figure 5 .
Figure 5: Connecting the STP15 to the DT3145 Board
J1
EP337
J2
DT3145
STP15