Data Translation DT3145, Getting Started Manual

Page: 25 / 60

Installing the Board and Configuring the Device Driver
17
3
3
3
3
3
3
3
3
3
Installing the Board
To install the DT3145 frame grabber board, you must set up the
computer, select an expansion slot, configure the trigger selection
jumper, if necessary, then insert the board into the computer.
Setting up the Computer
To set up the computer, perform the following steps:
1. Turn off the computer.
2. Turn off all peripherals (printer, modem, monitor, and so on)
connected to the computer.
3. Remove the cover from your computer. Refer to your computer’s
user manual for instructions.
Next, select an expansion slot, as described in the next section.
CAUTION:
To prevent electrostatic damage that can occur when handling
electronic equipment, use a ground strap or similar device when
performing this installation procedure.