■ List of Steps to Start a Job
≡
Installing Input/Output Media
PSV5000 Operator’s Manual
- 27 -
6.
Dry-run a few parts using the foot switch.
7.
Inspect the sealed tape for any wrinkles and creases (re-check alignment
of tapes), and ensure that the sealing quality is adequate.
8.
To adjust the outer heat shoe position, turn the outer sealer position
adjustment knob (as depicted below).
Figure 22:
Adjusting the outer heat shoe position.
9.
To adjust the inner heat shoe position, turn the inner sealer position
adjustment knob (access the knob from underneath the taper).
Figure 23:
Adjusting the inner heat shoe position.
10.
Confirm that taped devices are securely held in the take-up reel:
Perform a
peel-back/peel-force test
by peeling the cover tape from
the carrier tape, paying attention to how well they adhere.
Perform a
twist test
by giving the tape a slight twist, noting if the
cover tape detaches from the carrier tape.
If either test produces loose cover tape, increase the roller pressure of the
press sealer (turn the sealer adjustment screw clockwise).
If the cover tape is intact after completing both tests, then visually in-
spect the taped devices for any excess adhesive/glue. If adhesive is vis-
ible, then decrease the roller pressure (turn the sealer adjustment screw
counter-clockwise) and test again.
