Data General AViiON 530 Series, Customer Documentation, Page: 119 / 266

Expanding and Maintaining Your Computer System
6-15
014–002091
3. Push the top cover toward the front of the computer unit, as shown in
Figure 6Ć9 untilthe front edge of the top cover is flush with the front edge of
computer unit.
4. Using a coin or screwdriver, tighten the fastener by turning it one-quarter turn
clockwise as shown in Figure 6Ć9.
(Rear view of
computer)
Tighten fastener
1/4–turn.
Figure 6-9 Installing the Top Cover
Installing the Side Covers
After installing the top cover, follow the steps below to reinstall one or both side
covers. You will need a coin or a large flat-blade screwdriver.
1. If you have not done so already, remove the ESD clip from the computer unit
and take off the ESD wrist strap. Store the wrist strap in a safe place for future
use.
2. Insert the three tabs on the cover's bottom edge into the slots at the base of the
computer unit as shown in Figure 6Ć10.
Side cover
Slots
Computer unit
(side)
Figure 6-10 Inserting the Cover Tabs into the Computer Unit Slots