02-24-40
FALCON 7X
PAGE 4
/ 6
CODDE 1
ISSUE 2
ATA 24 – ELECTRICAL POWER
GROUND OPERATION
DGT 97831
DASSAULT AVIATION Proprietary Data
CIRCUIT BREAKER STATUS PAGE
The status of an SSPC can be changed on the circuit breaker page, accessible through the
TEST synoptic page (refer to 02-24-20). It will only be used per MMEL procedure.
The SSPC status can be changed only in the following conditions:
-
The airplane is on ground,
-
The park brake is pulled to the first notch position or higher.
The CHANGE SSPC STATE soft keys allow to change the status of the SSPC:
-
1) If the cyan selection box is on an electrical load where the state is IN, then the IN soft
key is non actionable (since it is already in this state), the OUT soft key is selectable, and
the LOCK soft key is non selectable. It can go from IN to OUT, but not from IN to LOCK.
-
2) If the cyan selection box is on an electrical load where the state is OUT, then the IN soft
key is selectable, the OUT soft key is not selectable (since it is already in this state), and
the LOCK soft key is selectable. It can go from OUT to IN and from OUT to LOCK.
-
3) If the cyan selection box is on an electrical load where the state is LOCK, then the IN
soft key is non selectable, the OUT soft key is selectable, and the LOCK soft key is not
selectable (since it is already in this state). It can go from LOCK to OUT, but not from
LOCK to IN.
