Darkglass Electronics MICROTUBES INFINITY, Owner'S Manual

Page: 3 / 12

3
MICROTUBES INFINITY: USER GUIDE
QUICK START GUIDE
Connect your instrument into the 1/4” INPUT.
Connect a compatible power supply (9V center
negative, min. 500 mA) to the power connector.
Connect at least one of the following:
· Headphones into the headphone jack
· USB-C cable between the USB connector and your
computer*
· Instrument cable between one of the balanced 1/4”
outputs and your amplifier’s input
· XLR cable between DIRECT OUTPUT and your
mixing desk or audio interface
The Microtubes Infinity is pre-programmed with
three presets, A, B, and C that are selectable via the
dedicated footswitches. Press and hold one of the
footswitches for two seconds to save your changes into
a preset. Three additional presets can also be accessed
via MIDI or the Darkglass Suite.
Adjust the level (and headphone volume, if applicable)
to your liking and start playing!
*Using the Microtubes Infinity as an audio interface
may require some extra steps depending on your
operating system
CONNECTIONS
INPUT
This is the primary instrument input on the
Microtubes Infinity. Connect your instrument or
output from your pedal board to the 1/4” mono jack.
AUX IN
The stereo input of the Microtubes Infinity enables
the playback of backing tracks while practicing or
recording. Connect your mobile phone, laptop etc. to
the 1/8” stereo jack.
HEADPHONE OUTPUT
The headphone output can handle headphones
with an impedance of 16 - 600 ohms. Connect your
headphones to the 1/8” stereo jack and set the
desired level from the dedicated potentiometer next
to the jack.
BALANCED OUTPUTS
The two balanced outputs add routing versatility
and the option of using the Microtubes Infinity
as a fully equipped audio interface. Connect your
studio monitors, amplifier or other effects to the 1/4”
balanced jacks using a TRS connector (Tip +, Ring -,
Sleeve GND).