©
National Instruments Corporation
I-1
SCXI-1102/B/C User Manual
Index
Numbers
+5 V signal (table), 3-3
A
analog circuitry, 4-3 to 4-4
analog bus switch, 4-4
analog input channels, 4-3
analog configuration, 2-4 to 2-5
bent and trimmed resistor (figure), 2-5
current-loop receivers, 2-4 to 2-5
analog input signal connections, 3-3 to 3-6
differential input signal range, 3-3 to 3-4
exceeding input level or range (caution), 3-4
ground-referencing of signals, 3-4 to 3-6
floating signal connections
referenced to chassis ground
(figure), 3-6
ground-referenced signal connections
(figure), 3-5
signal terminals, 3-3
analog input specifications, A-1 to A-3
amplifier characteristics, A-2
dynamic characteristics, A-2 to A-3
input characteristics, A-1
transfer characteristics, A-1 to A-2
analog output signal connections, 3-9
AOGND signal (table), 3-8
B
bent and trimmed resistor (figure), 2-5
bulletin board support, C-1
C
cables, custom, 1-6
calibration, 5-1 to 5-3
equipment requirements, 5-1 to 5-2
gain and offset calibration, 5-2 to 5-3
overview, 5-1
sample program, B-1 to B-4
CGND signal (table), 3-3
CH31+ through CH0+ signals (table), 3-3
CH31- through CH0- signals (table), 3-3
CJSENSOR signal (table), 3-3
cold-junction sensor connections, 3-6
ComponentWorks software, 1-3
configuration, 2-1 to 2-5
analog configuration, 2-4 to 2-5
bent and trimmed resistor (figure), 2-5
current-loop receivers, 2-4 to 2-5
digital configuration, 2-3 to 2-4
hardware installation, 2-6
parts locator diagram, 2-2
removing SCXI module cover (figure), 2-4
current-loop receivers, 2-4 to 2-5
custom cables, 1-6
customer communication, xii, C-1 to C-2
D
DAQD*/A signal
description (table), 3-8
SCXIbus to SCXI-1102/B/C to DAQ board
pin equivalencies (table), 3-10
DGND signal (table), 3-8
digital configuration, 2-3 to 2-4
