DAPAudio MA-460, Manual

Page: 9 / 16

8
Backpanel
Fig. 3
17. AC Inlet with integrated fuse holder
This connector is meant for the connection of the supplied main cord. Connect one end of the power
cord to the connector, the other end to the mains, then turn on the
power (16) switch to operate the
unit.
Make sure that the supply voltage matches the operation voltage before connecting the unit to mains.
Replace the fuse only with a fuse of the same specification (230V:T3,15A, 115V:T6,3A).
18. AC-selector
Before connecting your MA-460 to the mains, make sure the AC-selector is set to the proper voltage used
in your country. If you’re not sure, consult a skilled technician.
19 . Zone line out terminal
These terminals allow you to connect an external amplifier to a zone in case the internal amplifier can’t
provide sufficient power. The terminals allow you to connect a balanced or unbalanced amplifier input.
20 . Zone com speaker terminal
Connect these terminal with the – terminal of your zone speaker(s).
21. Zone 8Ω impedance speaker terminals
Connect this terminal to the + terminal of a 8
Ω
speakerload.
In case of using several speakers, make sure that the total speaker load is the same as the impedance of
the corresponding terminal. The total power rating of the low impedance speakers connected to this
terminal summed, should be at least 60W.
22. Zone 70V output terminal
Each zone has its own output terminal. Connect this terminal to the + terminal of your 70V high
impedance speaker load. In case of using several speakers make sure all speakers are wired in parallel.
The total power rating of the high impedance speakers connected to this terminal summed, should never
exceed 60W.
23 . Monitor line out terminal
These terminals allow you to connect an external monitor amplifier. The output level is controlled by the
monitor level (15) control.
24 . Monitor 8Ω 1W out terminal
These terminals allow you to connect an external 1W 8Ω monitor speaker. The output level is controlled
by the
monitor level (15) control.