DAPAudio MA-460, Manual

Page: 8 / 16

7
7. Zone VU meter
Indicates the signal level at the output of the corresponding zone. If the red LED blinks frequently or lights
continuously, the output is likely to enter clipping. If this happens, we strongly suggest lowering the
corresponding
zone level (8) control.
8. Zone level control
Use to adjust the output volume for zone 1-4.
9.Monitor button
Allows you to monitor one or more zones with your headphone (14) output or monitor (23, 24) outputs.
10. Power LED
Indicates the amplifier is turned on.
11. Channel level control
Use to adjust the level for channel 1-5.
12. Channel mute button
Pushing this button allows you to mute the corresponding channel. If a channel is muted, the
corresponding
mute (4) LED will light up.
13. Monitor VU meter
Indicates the signal level at the output of the corresponding zone. If the red LED blinks frequently or lights
continuously, the output is likely to enter clipping. If this happens, we strongly suggest lowering the
monitor level (15) control.
14. Monitor output
You can connect a pair of headphones with a minimum impedance of 32 Ohm to this stereo 1/4” jack.
The jack should be wired as Tip=left, Ring=right and sleeve=ground.
15. Monitor level control
Is used to adjust the volume level of your headphone (14) / monitor (23, 24) outputs.
16. AC power switch
This is the main Power switch. Push to turn the amplifier on.