7
Antenna Distributor
Ordercode: D1444
Backside
Fig. 02
DC-out
Supplies 12Vdc for powering up to four receivers.
IEC Power Inlet and Fuse
This connector is meant for the connection of the supplied main cord. Connect one end of the
power cord to the connector, the other end to the mains, then turn on the power switch (2) to
operate the unit.
Note:
Please make sure that the supply voltage matches the operation voltage before connecting
the unit to mains.
Replace the fuse only with a fuse of same specification
Antenna A in
Antenna A out
Antena B out
Antenna B in
Installation
Remove all packing materials from the Antenna Distributor. Check that all foam and plastic padding is
removed. Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
