DAPAudio Clubmate 12, Product Manual

Page: 10 / 14

8
Set Up and Operation
DAP Pro is proud to introduce the new Club mate Active speaker systems. These speaker systems are
especially designed for the mobile DJ's, where a powerful bass is required as well as a smooth mid–high
frequency response. The new developed 12" and 15" subwoofers have a long linear cone excursion
to ensure minimal distortion and high power levels as well as to get a higher maximum sound pressure.
Special attention is also given to the power ratings of the subwoofers and satellites as well as the
behavior of all the independent dynamic compressors and limiter circuits inside.
The satellite
The Club Mate satellite is designed to produce a mid/high spectrum of sound. The satellite is equipped
with a 8” LF loudspeaker and a 1” HF driver.
The subwoofer
Feel the bass with this 15” subwoofer. The subwoofer cabinet is powered through a powerful 400W
amplifier. The subwoofer also has a built in 2 x 150W amplifier for powering the satellites.
It’s easy to set up; All you have to do is set up the system components, connect the signal-carrying
cables and power cords and you're ready to roll.
Connecting
Connect the cables coming from the mixer to the Combo Line Input (3, 8) or the RCA Input (13, 14)
sockets of the subwoofer. Depending on the mixer’s output sockets use either a Jack, XLR or RCA cable.
Use a Speakon cable to connect the
To Satellite (12, 15) outputs of the subwoofer to the Speakon Input
(17) of the satellites.
Linking
Connect a standard microphone cable from the first unit’s Aux (11, 16) outputs to the second unit’s Line
Input (3, 8) . Repeat this for each stack. Make sure that when using multiple tops, they are placed with a
proper projection angle.
Note:
Do not supply power before all components of the system are set up and connected properly.
Make sure that the Club Mate system is always the last component, which is switched on! When shutting
down, the Club Mate should be the first system, to be switched off.