Dantherm HPP-iw Series, Owners & Installation Manual

Page: 23 / 308

23 1007332 ISSUE 5
a� Screen lock
1) Press for 3 seconds to lock or unlock the
screen. The buttons will turn dark when the controller
is locked
2) Automatic lock period: 30 seconds if no operation.
b� Power on
Press for 3 seconds to unlock screen.
Press to power on heat pump.
c� Temperature setting
Press and to display and adjust the set
temperature.
d� Mode selection
1. Heating/Cooling/Auto
Press to switch between heating,
cooling, and automatic modes.
Mode Symbol Water temperature
setting range
Heating 18-40°C
Cooling 12-30°C
Auto 12-40°C
e� Speed Mode selection
Press to switch between Boost mode and
Whisper mode.
Default mode: Boost.
Please choose Boost mode for initial heating.
f� Wi-Fi
When the screen is on, press for 3 seconds,
after flashes, enter Wi-Fi connection.
Connect Wi-Fi on mobile phone and input password,
then control equipment by Wi-Fi. When APP connects
Wi-Fi successfully
light is on.
g� Defrosting
1. Automatic defrosting: When the heat pump is
defrosting, the lamp flashes; after defrosting
the lamp stops flashing.
2. Forced defrosting: When the heat pump is heating
and the compressor has been running continuously
for at least 10 minutes, press
and
simultaneously for 5 seconds to start forced
defrosting.
The
lamp flashes and defrost starts,
when the lamp stops flashing defrosting stops.
The interval between forced defrosts must be more
than 30 minutes.
4�2 OPERATING INSTRUCTIONS
IMPORTANT
Remember that at startup there is a 1 minute time delay before the heat pump starts