11
Mounting and installation
Introduction
This section will guide you through the mounting and installation of the HEX 30.
Caution!
•
Only trained and certified technicians are allowed to replace parts
•
Switch of the DC supply before working on the unit
•
Make sure that all work has been performed before switching on the power again
Before you start
Make sure you have the following available before you start the installation:
•
8 M6 nuts
•
Cable with Sub-D 9 pole plug
Mounting
Follow this procedure to mount the unit to the inside of the enclosure door:
Step
Action
1
Mount 8 M6 nuts on the mounting
door without fastening them
2
Mount a gasket between the HEX
30 and the door; this is the IP bar-
rier against the outdoor environ-
ment
3
Place the HEX 30 on the door and
fasten the nuts
4
Connect power (48 V DC) to the
unit
061629 •
Ver
sion
1
.0 •
25.0
2.200
9
