49
Figure 4-36
Please refer to the following sheet for detailed information.
Parameter
Function
Enable
You need to check the box to enable motion detection function.
Sensitivity
There are six levels. The sixth level has the highest sensitivity.
Region
There are six levels. The sixth level has the highest sensitivity.
Region: If you select motion detection type, you can click this
button to set motion detection zone. The interface is shown as
in Figure 4-36. There are PAL 22X18/NTSC 22X15 zones. Right
click mouse you can go to full-screen display mode. Do
remember clicking OK button to save your motion detection
zone setup.
Working
Period
Motion detection function becomes activated in the specified
periods. See Figure 4-35.
There are six periods in one day. Please draw a circle to enable
corresponding period.
Select date. If you do not select, current setup applies to today
only. You can select all week column to apply to the whole
week.
Click OK button, system goes back to motion detection
interface; please click save button to exit.
Anti-dither
System only memorizes one event during the anti-dither period.
The value ranges from 0s to 100s.
Relay out
Enable alarm activation function. You need to select alarm output
port so that system can activate corresponding alarm device when
alarm occurs.
Alarm Delay
System can delay the alarm output for specified time after alarm
ended. The value ranges from 10s to 300s.
Summary of Contents for DNA1982
Page 51: ...48 Figure 4 34 Figure 4 35...
Page 58: ...55 Figure 4 41 Figure 4 42...
Page 59: ...56 Figure 4 43 Figure 4 44...