48
48
48
48
Note
Configuration first priority is always on “SCHEDULE” of “RECORD”.
Thus, the system will not notify alarm message upon motion alarm or sensor even
though user ticks the check-box of above event selection, unless user sets the
“SCHEDULE” of “RECORD” and “MOTION”/”SENSOR” of “DEVICE” accordingly.
For example, If user sets just “Continuous” only in “SCHEUDLE” of “RECORD” and tick
“All” check-box of “REMOTE NOTIFY”, then the system will not notify alarm message.
In this case, user has to set “CONT + MOT”, “MOTION”, “SENSOR”, or “CON + SENS”
to enable REMOTE NOTIFY properly.
Note
User can set remote pop-up in RemoteManager S/W (RMS) and Central Management
S/W (CMS) upon alarm trigger in DVR.
In order for RMS user to receive an instant pop-up video over network from DVR, DVR
user has to tick “SENSOR” or “MOTION ALARM” in above menu.
“SENSOR” means the alarm triggered by physical alarm, while “MOTION ALARM”
means the alarm triggered by motion detection.
E-MAIL NOTIFY
The system can make an email notification to the IP address of Remote Manager PC and Central
Management PC over the network.
User can choose various different kinds of alarms by pressing “ADD” for such as Log-in/Out,
System start, Sensor, Video loss, Recording failure, Setup, Shutdown, Motion alarm, S.M.A.R.T.,
and HDD full. The maximum number of email recipient is 5.
Note
Configuration first priority is always on “SCHEDULE” of “RECORD”.
Thus, the system will not email alarm message upon motion alarm or sensor even
though user ticks the check-box of above event selection, unless user sets the
“SCHEDULE” of “RECORD” and “MOTION”/”SENSOR” of “DEVICE” accordingly.
For example, If user sets just “Continuous” only in “SCHEUDLE” of “RECORD” and tick
“All” check-box of “REMOTE NOTIFY”, then the system will not make email notification.
In this case, user has to set “CONT + MOT”, “MOTION”, “SENSOR”, or “CON + SENS”
to enable Email Notification properly.
Summary of Contents for DLW5400
Page 3: ......