Dannmar DJ Series, Installation And Operation Manual

Page: 14 / 36

DJ Series of Rolling Jacks
14
P/N 5900258 — Rev. A — October 2020
8. Remove the Nyloc Nuts at the top of the Bolt Threads coming up from the top of the Roller.
9. Put a Safety Bracket into place on the Bolt Threads—the Bracket goes on the Rolling Jack side;
securely tighten the Nyloc Nuts in place.
Side view. Not necessarily to scale. Not all components shown.
⚠
WARNING You are
required
to install a Safety Bracket around each of the four Rollers of the
Rolling Jack. They ensure the Jack stays in place on the Utility Rails. If you do not
install the Safety Brackets, there is a possibility the Rolling Jack could fall off the Lift,
causing damage or injury.
10. Install the Safety Brackets on the other three Rollers of the Rolling Jack.
11. If you are installing two Jacks on the Lift, repeat Steps 2 through 10.
12. If you haven’t already, raise the Lift and engage the Lift on a Safety Lock.
⚠
WARNING Do
not
start using the Rolling Jack until you are certain the Four-Post Lift is
engaged on its Safety Locks
. If the Lift is not engaged on its Safety Locks, it
could move, possibly causing it to fall off, and possibly causing damage or injury.
13. Check the clearance around, and movement of, the Rolling Jack.
14. If necessary, make adjustments to ensure proper operation.
Do not use your Rolling Jack unless it is safe to do so!