Danish Interpretation Systems
User Manual
Manual 01 18 04440
11
shows the number of errors encountered on the
incoming and outgoing busses since last error reset.
If the number of errors on the outgoing bus exceeds
a certain amount the AO 6008 can no longer decode
the audio data correctly and the audio is muted. The
audio is re-enabled when the communication is
normalised. The error counters are reset by pressing
the Reset key.
Ver. and serial no. menu
The serial number and the unit address can be
checked from the display by entering the Ver. and
serial no. menu.
From this menu the software and hardware version
can also be viewed.
As usual the menu is left with the MENU key.
Clipboard menu
From this menu the user can save the settings of the
AO 6008 temporarily in the CU 6010. This feature
is to be used when settings must be copied from one
AO 6008 to another.
The menu holds two entries:
When a user wants to copy settings to another AO
6008 he executes the “Copy to clipboard” command
after he has finished setting up all the channels and
volume settings. This brings out a confirmation
display:
The settings are then transferred to another unit by
executing the “Paste from clipboard” command on
that unit.
The “Paste from clipboard” command brings out a
confirmation display:
If the user presses ENTER the settings of the unit
are replaced by the settings stored in the clipboard.
The settings stored in the clipboard are:
•
Channel settings for all 8 outputs
•
Volume settings for all 8 outputs
Storing AO 6008 settings
Each time the user changes the language or volume
for an output on an AO 6008 it is communicated to
the CU 6010. This means that the CU 6010 always
has an updated copy of the AO 6008 unit’s settings
and it is therefore possible to store the settings in
non-volatile memory on the CU 6010 by executing
the “Save to FLASH” command on the CU 6010. In
this way the settings for each AO 6008 will be
recalled automatically when powering up the
system.
If the “Save to FLASH” command is not executed
the settings are only stored as long as the CU 6010
has power. If an AO 6008 Unit is removed and
reinserted while there is power on the CU 6010 the
AO 6008 will keep its settings but if the system is
powered off and on again the AO 6008 will get the
settings stored in FLASH.
Original Attenuation menu
The Original Attenuation menu gives access to
setting the attenuation level. In systems where
channel selectors are used along with delegate
microphones acoustic feedback can occur. This
effect can be minimized by lowering the volume on
the selected channel or the attenuation when it is
AO 6008 rev A
Version: 053.017
Serial #: 200.007.123
Address: 1
-Copy to clipboard
-Paste from clipboard
This will replace
current settings!
Proceed?
Settings copied
to clipboard!
