Pg 10
Pg 11
D A N I E L A A P P L I A N C E S . C O M . A U
D A N I E L A A P P L I A N C E S . C O M . A U
I N S T A L L A T I O N I N S T R U C T I O N S
Positioning the Appliance
Position the appliance in the desired location. The back should rest
against the wall behind it, and the sides, along the adjacent cabinets or
walls. The dishwasher is equipped with water supply and drain hoses that
can be positioned either to the right or the left sides to facilitate proper
installation.
Levelling the Appliance
Once the appliance is positioned for
levelling, the height of the dishwasher
may be altered via adjustment of the
screwing level of the feet.
Electrical Connection
WARNING
For personal safety:
DO NOT USE AN EXTENSION CORD OR AN ADAPTER PLUG WITH THIS
APPLIANCE. DO NOT, UNDER ANY CIRCUMSTANCES, CUT OR REMOVE
THE EARTHING CONNECTION FROM THE POWER CORD.
Use the required fuse 10-amp, time delay fuse or circuit breaker
recommended and provide separate circuit serving only this appliance.
Ensure the voltage and frequency of the power supply corresponds to
those on the rating plate. Only insert the plug into an electrical socket
which is earthed properly. If the electrical socket to which the appliance
must be connected is not appropriate for the plug, replace the socket,
rather than using an adaptor or the like as they could cause overheating
and burns.
Grounding Instructions
This appliance must be earthed. In the event of a malfunction or
breakdown, earthing will reduce the risk of electric shock by providing a
path of least resistance for the electric current. This appliance is equipped
with a cord having an equipment-earthing conductor and an earthing plug.
The plug must be plugged into an appropriate outlet that is installed and
earthed in accordance with all local standards and requirements.
How to Connect the Safety Supply Hose
The appliance must be connected to the water mains using new hose-sets. The old
hose-sets should not bereused.
Water pressure must be between 0,04 MPa and 1 MPa. If the pressure is below the
minimum consult our Service Department for advice.
1. Pull The safety supply hoses completely out from storage compartment located
at rear of dishwasher.
2. Tighter the screws of the safety supply hose to the faucet with thread
3/4inch.
3. Turn water fully on before starting the dishwasher.
The safety supply hose consists of the double walls. The hose's system guarantees
its intervention by blocking the flow of water in case of the supply hose breaking
and when the air space between the supply hose itself and the outer corrugated
hose is full of water.
WARNING: A hose that attaches to a sink spray can burst if it is installed on the
same water line as the dishwasher. If your sink has one, it is recommended that
the hose be disconnected and the hole plugged.
How to Disconnect the Safety Supply Hose
1. Turn off the water.
2. Release the water pressure by depressing the pressure release button. This
relieves water pressure and protects you, and the room, from severe splashing.
3. Unscrew the safety supply hose from the faucet.
Cold Water Connection
Connect the cold water supply hose to a threaded 3/4(inch) connector and make
sure that it is fastened tightly in place. If the water pipes are new or have not been
used for an extended period of time, let the water run to make sure that the water
is clear and free of impurities. If this precaution is not taken, there is a risk that the
water inlet can get blocked and damage the appliance.
I N S T A L L A T I O N I N S T R U C T I O N S
