P
I
02 9604 1226 E
I
|
danielaappliances.com.au
PAG E 9
ELECTRICAL CONNECTION
Those ovens equipped with a three-pole power supply cable are designed to operate with an
alternating current. The wire for earthling the appliance is yellow-green in colour.
FITTING ON A POWER SUPPLY CABLE
Opening the terminal board:
•
Using a screwdriver, prize the bolt on the side tabs of the terminal board cover;
•
Unscrew the bolt, pull open the cover of the terminal board.
To install the cable, proceed as follows:
•
Remove the wire clamp screw and the three contact screws L-N –
•
Fasten the wires beneath the screw heads using the following colour scheme:
Blue (N) Brown (L) Yellow-Green
•
Fasten the supply cable in place with the clamp and close the cover of the terminal board.
CONNECTING THE SUPPLY CABLE TO THE MAINS
Install a standardized plug corresponding to the load indicated on the data plate. When
connecting the cable directly to the mains, install an omni polar circuit breaker with a minimum
contact opening of 3 mm between the appliance and the mains. The omni polar circuit breaker
should be sized according to the load and should comply with current regulations (the earth wire
should not be interrupted by the circuit breaker).
