45
www.Daniel.com
USER MANUAL
values, sequencing patterns and application rates provided here to achieve an adequate
seal.
Tighten each fastener at the following application rate:
•
Install Nut - apply less than 20% of the suggested torque
•
Second Pass - apply 20% - 30% of the suggested torque
•
Third Pass - apply 30% - 70% of the suggested torque
•
Fourth Pass - apply 100% of the suggested torque
•
Fifth Pass - apply 100% of the suggested torque four (4) hours after Fourth Pass
Table 9-1: Valve cylinder head to body (stud-nut) suggested starting torque values by
stud material
(1)(2)
B7M / L7M
Stud size (in)
Suggested starting torque
range lbf·ft (N·m)
B7 / L7
Stud size (in)
Suggested starting torque
range lbf·ft (N·m)
Lower limit
Upper limit
Lower limit
Upper limit
3/8 - 16
21 (28)
24 (32)
3/8 - 16
28 (38)
31 (42)
7/16 - 14
27 (36)
30 (41)
7/16 - 14
35 (48)
39 (54)
1/2 - 13
41 (55)
45 (61)
1/2 - 13
53 (72)
59 (80)
5/8 - 11
79 (107)
88 (119)
5/8 - 11
103 (140)
115 (156)
3/4 - 10
137 (186)
153 (207)
3/4 - 10
180 (244)
200 (271)
7/8 - 9
218 (296)
243 (329)
7/8 - 9
287 (388)
319 (432)
1 - 8
325 (440)
361 (490)
1 - 8
426 (578)
474 (642)
1- 1/8 - 8
470 (638)
523 (708)
1-1/8 - 8
617 (837)
686 (930)
1-1/4 - 7
640 (867)
710 (963)
1-1/4 - 7
839 (1138)
932 (1264)
1- 3/8 - 8
878 (1191)
976 (1323)
1-3/8 - 8
1153 (1563)
1281 (1737)
(1)
Values are FOR REFERENCE only.
Daniel
provides the torque values in this table to help users
establish a starting point to achieve an adequate unit assembly clamping force. Torque values
reflect threads and nut bearing surfaces being bare metal well-lubricated with thread compound
assembled in a controlled factory environment.
(2)
The final torque required to achieve an adequate seal may be higher or lower than the range
provided in this Table
Planned maintenance
User manual
November 2020
P/N 3-9008-553
54
Daniel Series 700 Control Valve