Dangrill 90745, Instruction Manual

Page: 23 / 55

23
NO
SE
FI
GB
DE
DK
PL
ET
The gas bottle must be changed outside at
a safe distance from naked � ames and other
sources of ignition.
If you discover a leak, turn off the gas supply
at the regulator immediately and avoid
naked � ames and other sources of ignition.
Wait a few minutes until the area has aired.
Carry out a leak test when you connect a
new gas bottle or if the barbecue has not
been used for a prolonged period. Do not
carry out the leak test using a naked � ame!
See ‘Leak test’.
Turn off the gas supply using the regulator
after use.
Do not attempt to modify the barbecue,
including the regulator and the burners. Do
not try to open parts that have been sealed
at the factory.
Use barbecue gloves when handling the
barbecue.
Open the lid before you light the barbecue!
If you try to light the barbecue while the lid
is closed, you may cause a gas explosion!
Use separate cooking utensils for raw and
cooked meat. Keep them separate to avoid
transfer of bacteria to the cooked meat and
the risk of food poisoning.
Assembly
Please refer to the illustrations at the back
of the user instructions. It takes 2 people to
assemble the barbecue.
1. Fit the left legs (9A, 9B) securely to the
left side of the barbecue unit (1) using 4
screws (C).
2. Fit the right legs (16A, 16B) securely to
the right side of the barbecue unit (1)
using 4 screws (C).
3. Fit the base plate between the 4 legs
using 1 screw (C) in each corner.
4. Insert the wheel shaft (12) into the holes
at the bottom of the right legs (16A,
16B). Place a washer (E), a wheel (13), a
washer (E) and a nut (B) on each end of
the axle.
5. Fit a wheel cap (14) to each wheel (13).
6. Screw the front plate (10) securely
between the two front legs (9A, 16A)
using 4 screws (H).
7. Screw 2 screws (H) into the holes on
the left side of the control panel on
the barbecue unit (1). Slide the left
side table (6) on over the 2 screws and
tighten the screws.
8. Screw the left side table securely to the
barbecue unit from the inside using 2
washers (A) and 2 screws (H).
9. Screw the left side table securely to the
barbecue unit from the outside using 4
screws (H).
10. Screw 2 screws (H) into the holes on
the right side of the control panel on
the barbecue unit (1). Slide the right
side table (18) on over the 2 screws and
tighten the screws.