Danfoss VLT OneGearDrive, Operating Manual

Page: 36 / 44

-
-
-
e30bc425.11
1
2 3
4
8
7
5
6
9
1 Disk (DIN 125-A10 5)
2 Nut (DIN 934 M10)
3 Disk (DIN 9021 10, 5x30x25)
4 Nut (DIN 985 M10)
5 Disk (Ø73x3 stainless steel)
6 Customer frame
7 Barrel (POM-C white)
8 Bushing (stainless steel)
9 Screw (stainless steel)
Illustration 30: Mounting Set
N O T I C E
The set also contains 3xDIN 933, M10x25, 8.8, stainless steel screws. The tightening torque is 49 Nm (433.7 in-lb).
Only use the original Danfoss or comparable mounting set to mount the VLT® OneGearDrive® to the conveyor. The mounting
equipment used must ensure the same degree of flexibility as the original Danfoss mounting set. Do not screw the torque
arm directly onto the conveyor frame.
9.7.2 Mechanical Brake
The VLT® OneGearDrive® Standard is available with a 180 V DC/400 V AC or a 220 V DC/480 V AC brake option. This mechanical
brake option is intended for emergency stop and park brake duty. Spring-loaded brakes are safety brakes that continue to work if a
power failure or usual wear occurs. As other components could also fail, take suitable safety precautions to avoid any injury to per-
sons or damage to objects caused by operation without a brake.
W A R N I N G
SEVERE OR FATAL INJURIES
The VLT® OneGearDrive® is designed exclusively for horizontal conveyor applications with or without any angle (inclined belt
conveyor). Using the VLT® OneGearDrive® in vertical lifting and hoisting applications can cause danger of fatal injury if the hoist
falls.
Do not use the brake in safety relevant vertical lifting and hoisting applications.
AQ347551551757en-000101 / 130R0239 36 | Danfoss A/S © 2020.12
Specifications
VLT® OneGearDrive®
Operating Guide