![background image](http://html1.mh-extra.com/html/danfoss/vlt-automationdrive-fc-361/vlt-automationdrive-fc-361_operating-manual_3730597066.webp)
10.8 Fastener Tightening Torques
Apply the correct torque when tightening fasteners in the locations that are listed in
. Too low or too high torque
when fastening an electrical connection results in a bad electrical connection. To ensure correct torque, use a torque
wrench.
Location
Bolt size
Torque [Nm (in-lb)]
Mains terminals
M10/M12
19 (168)/37 (335)
Motor terminals
M10/M12
19 (168)/37 (335)
Ground terminals
M8/M10
9.6 (84)/19.1 (169)
Load sharing terminals
M10/M12
19 (168)/37 (335)
Relay terminals
–
0.5 (4)
Door/panel cover
M5
2.3 (20)
Gland plate
M5
2.3 (20)
Table 10.6 Fastener Torque Ratings
Specifications
VLT® AutomationDrive FC 361
64
Danfoss A/S © 06/2018 All rights reserved.
MG06I102
10
10