Danfoss vlt aqua, Design Manual

Page: 219 / 228

No. Description Warning Alarm/Trip Alarm/Trip Lock Parameter Reference
60 External Interlock X
62 Output Frequency at Maximum Limit X
64 Voltage Limit X
65 Control Board Overtemperature X X X
66 Heatsink Temperature Low X
67 Option Configuration has Changed X
68 Safe Stop Activated X 1)
69 Pwr. Card Temp X X
70 Illegal Adjustable Frequency Drive configuration X
71 PTC 1 Safe Stop X
X 1)
72 Dangerous Failure X 1)
73 Safe Stop Auto Restart
79 Illegal PS config X X
80 Drive Initialized to Default Value X
91 Analog input 54 wrong settings X
92 NoFlow X X 22-2*
93 Dry Pump X X 22-2*
94 End of Curve X X 22-5*
95 Broken Belt X X 22-6*
96 Start Delayed X 22-7*
97 Stop Delayed X 22-7*
98 Clock Fault X 0-7*
No. Description Warning Alarm/Trip Alarm/Trip Lock Parameter Reference
220 Overload Trip X
243 Brake IGBT X X
244 Heatsink temp X X X
245 Heatsink sensor X X
246 Pwr.card supply X X
247 Pwr.card temp X X
248 Illegal PS config X X
250 New spare part X
251 New Type Code X X
Table 8.2: Alarm/Warning code list
(X) Dependent on parameter
1) Can not be Auto reset via par. 14-20
Reset Mode
A trip is the action when an alarm has appeared. The trip will coast the motor and can be reset by pressing the reset button or make a reset by a digital
input (Par. 5-1* [1]). The original event that caused an alarm cannot damage the adjustable frequency drive or cause dangerous conditions. A trip lock
is an action that occurs in conjunction with an alarm, which may cause damage to the adjustable frequency drive or connected parts. A trip lock situation
can only be reset by power cycling.
LED indication
Warning yellow
Alarm flashing red
Trip locked yellow and red
VLT
®
AQUA Drive Design Guide 8 Troubleshooting
MG.20.N5.22 - VLT
®
is a registered Danfoss trademark
8-3
8