4
VMBQE102
2 .3 Condensation line
The condensation line has a 15 mm internal thread connection and is connected to the underneath of the
heat recovery unit. The condensation line is supplied with a water seal before the line runs to the outlet
funnel.
2 .4 Electrical Installation
Electrical connection
The Danfoss Vent heat recovery unit is classed as a drip proof variant.
Air handling system group B according to the high current regulations.
The unit is supplied with a plug and must be connected to an earthed, 1 phase 230 V wall socket.
Switch
The unit is started and stopped using the switch, located under the control panel.
In position 0 the unit’s electrical components should be treated as conductors.
Electrical connection circulation pump
Circulation pump, CP, for Danfoss Vent is not electrically connected at delivery.
The circulation pump in the Danfoss Vent heat recovery unit must not be electrically connected until the
system has been filled with water.
Connect the circulation pump electrically as follows:
NOTE! The system must be filled with water .
1 Remove the cover marked ”FILTER ”.
2 You will now see the circulation pump behind the cover.
3 Electrically connect the circulation pump in the Danfoss Vent heat recovery unit by connecting the joint
connectors.
Capacity diagram Fan 120W
Summary of Contents for Vent
Page 11: ...11 VMBQE102...
Page 12: ...VMBQE102...