•
•
•
•
•
•
•
•
•
•
•
•
•
•
10.178 (ID 434) Fault
Location in the menu:
P2.3.3.3
(Multi-purpose Control Application)
P2.3.1.3
(Pump and Fan Control Application)
Use this parameter to select a digital output for the
Fault
status.
TTF programming method must be applied to this parameter (see
10.626 "Terminal to Function" (TTF) Programming Principle
).
10.179 (ID 435) Inverted Fault
Location in the menu:
P2.3.3.4
(Multi-purpose Control Application)
P2.3.1.4
(Pump and Fan Control Application)
Use this parameter to select a digital output for the fault inverted status.
TTF programming method must be applied to this parameter (see
10.626 "Terminal to Function" (TTF) Programming Principle
).
10.180 (ID 436) Warning
Location in the menu:
P2.3.3.5
(Multi-purpose Control Application)
P2.3.1.5
(Pump and Fan Control Application)
Use this parameter to select a digital output for the
Warning
status.
TTF programming method must be applied to this parameter (see
10.626 "Terminal to Function" (TTF) Programming Principle
).
10.181 (ID 437) External Fault or Warning
Location in the menu:
P2.3.1.6
(Pump and Fan Control Application)
P2.3.3.6
(Multi-Purpose Control Application)
Use this parameter to select a digital output for the external fault status.
TTF programming method must be applied to this parameter (see
10.626 "Terminal to Function" (TTF) Programming Principle
).
Fault or warning depending on parameter
ID 701
.
10.182 (ID 438) Reference Fault or Warning
Location in the menu:
P2.3.1.7
(Pump and Fan Control Application)
P2.3.3.7
(Multi-Purpose Control Application)
Use this parameter to select a digital output for the AI reference fault status.
TTF programming method must be applied to this parameter (see
10.626 "Terminal to Function" (TTF) Programming Principle
).
Fault or warning depending on parameter
ID 700
.
10.183 (ID 439) Drive Overtemperature Warning
Location in the menu:
P2.3.1.8
(Pump and Fan Control Application)
P2.3.3.8
(Multi-Purpose Control Application)
Use this parameter to select a digital output for the overtemperature fault status.
TTF programming method must be applied to this parameter (see
10.626 "Terminal to Function" (TTF) Programming Principle
).
The heat sink temperature exceeds the warning limit.
10.184 (ID 440) Reverse
Location in the menu:
P2.3.1.9
(Pump and Fan Control Application)
P2.3.3.9
(Multi-Purpose Control Application)
AB296635287482en-000301 / DPD00903 | 221
Danfoss A/S © 2023.02
Parameter Descriptions
VACON® NX All-in-One
Application Guide
Summary of Contents for VACON NX
Page 1: ...Application Guide VACON NX All in One drives danfoss com...
Page 2: ......
