1
2
3
Holder set installation:
Fix two hangers to the wall with attached screws and
dowels. Make sure, that the attached dowels are suitable
for the type of wall; if necessary, replace the dowels with
suitable types in the same size. Aware of the selection of
the place, at least on the right side approximately 50 cm
space for disassembly of the heat exchanger must remain.
Upper planes of hangers should be horizontal and at the
same level.
Wall mounting:
Place the system in the center and hang it with the angled
part of the base plate. After that secure the system with the
enclosed metric screws and press against the wall.
Check if the system is securely fixed and cannot be moved.
Insulation removal:
First remove pumps insulations (IP) by pulling them out
from the sockets. These parts are flexible and can be
removed easier by pressing them.
H
H
IP
IP
2 | © Danfoss | 2018.01
VQ.LZ.A1.02
Quick Guide ThermoDual®-FLS-COMBI
VQLZA102_ThermoDual-FLS-combi_180110.indd 2
2018-01-10 13:44:58
