Shaft assembly
L100
L10
L20
L50
L40
L30
L60
L70
P106 181E
Inspection
1. Inspect the seal carrier, the new seal and the O-ring for any damage or nicks.
2. Inspect the shaft and bearing for rust, wear, or contamination. Spin the bearing in your hand feeling
for roughness. Replace if necessary.
Reassembly
1. Using the arbor press, press the new seal (L40) into seal carrier (L30). Be careful not to damage the
seal.
If the shaft is not being replaced proceed to step 3.
2. Place roller bearing assembly on new shaft and secure with the retaining ring.
3. Install an installation sleeve or wrap spline or keyed end of shaft with plastic film to prevent damage
to the sealing lip on the seal during installation.
Service Manual
Series T90 Axial Piston Pumps
Minor repair
©
Danfoss | March 2020
AX216086485386en-000101 | 45