Danfoss Link DBR, Installation Manual

Page: 11 / 36

11
VIIOS202 © Danfoss 07/2017
Installation Guide Danfoss Link™ DBR Installation Guide Danfoss Link™ DBR
Configure settings of the Danfoss Link
TM
DBR
Setpoint Limits
Configure the Minimum
Temperature and Maximum
temperature for Return Line
setpoint temperatures for
Danfoss Link™ DBR here.
(Note: You can only set these
setpoint limits within the
Dynamic mode.)
The recommended Maximum Temperature is below 54 degrees to
ensure maximum efficiency with condensing boilers.
If Maximum Temperature is set too low, there is a risk of not reaching
the desired temperature.
NL
UK
Green LED OFF Relay OFF/Standby
Green LED ON Relay ON/Heating
Green LED fast flash Adding or link test
Green LED short flash Ready for adding
Red LED slow flash Adding not OK
Link test not OK
Safe State Active
Status indicator
Turn off the power to the device, then press and hold the install
button in front of the device for approx. 5 sec. while the power
is switched on again. The button must be held until LED gives a
red flash.
Factory reset
Once the Danfoss Link™ DBR and all other devices in the system
have been registered and the Danfoss Link™ CC is placed in
its final position, perform a
network test
(see
separate Danfoss Link™ CC manual).
Note: If the connection to the Danfoss Link™ CC is
lost for more than 1½ hour, the Danfoss Link™
DBR will go into safety mode. In this mode the
boiler will be turned ON continuously.
Perform network test
FR