Danfoss ISD Encoder Box, Operating Instructions Manual, Page: 16 / 44

No. Name Line Type Cross-section Flexible Cable
1 ISD Power Supply Module – – –
2 ISD Connection Box – – –
3 Feed cable Hybrid cable (DC & CAN)
1/2.5 mm
2
X (only with 2.5 mm
2
)
4 Terminating resistor Connector with terminating
resistor – –
5 ISD Encoder Box – – –
6 Master – – –
7 Control Cabinet – – –
– Ethernet Ethernet cable 4 x 2 x 0.27 mm², shielded
twisted pairs (CAT 5) X
– CAN line CAN cable (screened)
4 x 0.25 mm 2
–
– Encoder line Encoder cable
4 x 0.25 mm 2
–
– Loop cable Hybrid cable (DC & CAN)
1/2.5 mm 2 X (only with 2.5 mm 2 )
– DC cable Single wire
1.5 mm 2
–
– AC feed Single wire
1.5 mm 2
–
Table 4.3 Legend to Illustration 4.3
4.3.3 Connections
130BD090.10
Run/Err
Power
CAN I
Warn Err
0
CAN-ID
CAN II
RS232
Service
Set
2 8
6
4
ISD
Encoder Box
SD Card
Power
GND FE +24V
X201
CAN I
in out
GND Lo Hi Vc
c
GND Lo Hi Vc
c
CAN II
in out
GND Lo Hi Vc
c
GND Lo Hi Vc
c
in1+ in1 in2+ in2 in3+ in3 GND out1+ out1 GND out2+ out2
RS 422
X501 X502 X601 X602
-
- -
- -
Illustration 4.4 Connections on the ISD Encoder Box
Inscription Function Designation
Power 24 V Power supply X201
CAN I (in / out) Connection CAN line I X501
CAN II (in / out) Connection CAN line II X502
RS 422-I Connection encoder I X601
RS 422-II Connection encoder II (currently
not in use) X602
SD SD card slot –
Table 4.4 Connections on the ISD Encoder Box
4.3.3.1 24 V Power Supply (X201)
130BD094.10
Illustration 4.5 24 V Housing and Plug
Pin Signal Description Cross-Section
1 GND_24 V Power Supply Input (DC Ground) 1 mm 2
2 FE Functional- Earth connection
1 mm
2
3 +24 V Power Supply Input (DC 24 V)
1 mm
2
Table 4.5 Connector Pin Assignment
Description
VLT
®
ISD Encoder Box Operating Instructions
14 MG75F102 - VLT
®
is a registered Danfoss trademark
4 4