IKORE B General Safety
The following safety instructions must be read carefully to install and use the product properly, and to
keep it in perfect working condition, and to reduce the risk of misuse.
•
Strictly adhere to the installation instructions contained in this document.
•
Make sure that professional and competent personnel carry out the installation.
•
Ensure that all site and prevailing safety regulations are fully respected.
•
Make sure that this document is permanently available to the operator and maintenance personnel.
•
Keep the transmitter out of reach of non-authorized personnel.
•
Remove the transmission key when the set is not in use.
•
Check each working day the STOP button and other safety measures. When in doubt, press the STOP
button.
•
Whenever several sets have been installed, make sure the transmitter is the right one. Identify the
machine controlled on the label for this purpose on the transmitter or by using the display (in case it
has one).
•
Service the equipment periodically.
•
When carrying out repairs, use spare parts supplied by Danfoss only.
W
Warning
Potential damage to the operator or the product. Do not use this product on machines in potentially
explosive atmospheres unless the model is ATEX/RATEX certified to work in such conditions.
IKORE B Safety Warnings
Potential damage to operator and product.
Follow the guidelines below to reduce risk of injury to the operator and the product.
•
Use the device with the manufacturer's battery and battery charger (if applicable).
•
Only allow qualified personnel to operate the equipment.
•
Always set the STOP button in the off position when not in use.
•
Always press STOP before plugging in tether cable (if applicable).
•
Remove the Tether connection on the transmitter First (if applicable).
•
Do not operate product when visibility is limited.
•
Make sure product is compatible with the machine.
•
Avoid knocking or dropping the product.
•
Do not use the product if a failure is detected.
Changes or modifications not approved by Danfoss can void the user's authority to operate this product.
Quick reference precautions
Tx Cr 1
Cr 1
Remove the EEPROM in order
to disable the transmitter
When in doube, press the
STOP button
Make sure the transmitter
works with the machine
to be handled
Do not use the set when
visibility is limited
Avoid knocking or dropping
the set
User Manual
IKORE B Transmitter
Safety instructions
4 |
©
Danfoss | May 2021
BC292582855621en-000201
