IK Transmitters Start up (400-900Mhz)
Use the information below to properly turn the transmitter ON (OPERATION mode).
1. Place a charged battery in the transmitter. The charge must be done following the instructions of the
Battery Chargers' Manual.
2. Turn the contact key.
1
crane xx1
0
1
0
1
LED pulse
display op
�
on
LED pulse
3. Push and pull out the STOP button.
LED will flash orange-green pulse. If the transmitter has LCD, it displays the identification of the
machine and battery level (only if it has been pre-programmed).
crane xx1
LED pulse
Display option
4. Press the start button. The green LED will now light to indicate the transmitter is transmitting. Once
the Tx is connected, press any maneuver button and its corresponding relay will be activated. Check
to make sure all other maneuvers work in a coherent way with the expected movements.
1
crane xx1
0
1
0
1
LED pulse
display op
�
on
LED pulse
IK Transmitters Start up (2.4 GHz)
In order to turn the transmitter ON (OPERATION mode), please follow these steps:
User Manual
Remote Control IK3 Transmitters
Technical description
©
Danfoss | May 2021
BC290857689420en-000201 | 7
