WARNING!
Danger from tilting machine!
The machine may tilt if it is transported improperly. There is a risk
of being injured.
• Only lift the machine at the designated points.
1.
Lift the machine using the lifting lug (1) and transfer it to the in-
stallation site.
4.2 Intermediate storage of machine/unit
If the machine/unit cannot be mounted immediately upon delivery, it
must be protected against:
•
Contamination,
•
Weather influences,
•
Mechanical damage.
The machine/unit components may only be stored in closed rooms
and under the following conditions:
•
temperature between 10°C and 35°C,
•
maximum air humidity 80% (non-condensating).
4.3 Commissioning
The machine is commissioned by the customer's fitter.
1.
Place the machine hanging on the lifting lug on the optionally
supplied table.
2.
Position the cutting plate flush with the table edge.
3.
Bolt the machine on the bench.
Place the machine in a way so that it is easily accessible for main-
tenance work from all sides.
4.
Check the machine for damage.
Summary of Contents for ET9550
