Installation and Operation Guide
ED-DT318B
Drive Train Systems with Traction Control, Inverter/Controller, and Motor with 2 Speed Transmission
BC353060341319en-000101
© Danfoss | November 2020 | 178
12
Appendix D: Safety Notices
These safety notices are contained in the body of the document and are repeated here as a quick reference. If
there are any questions about one or more of these notices, the appropriate section of this document should be
reviewed.
Section 1
DANGER
Dangerous voltages, currents, and energy levels exist in this product. Exercise extreme
caution in the application of this equipment. Only qualified individuals should attempt
to install, set-up, and operate this equipment.
DANGER
Incorrect motor and controller wiring can cause catastrophic failure. Proper connection
of motor cables, signal cable, and DC cable are necessary for safe operation. Do not
swap motor windings to reverse direction.
Section 1.1.4
DANGER
Exposure to high voltage can cause shock, burns, and even death.
Technicians with special training and knowledge are required to service the high
voltage components in the vehicle.
High voltage components are identified by labels. Do not remove, open, take apart, or
modify these components.
High voltage cable or wiring has an orange covering. Do not probe, tamper with, cut,
or modify high voltage cable or wiring.
Section 1.2
WARNING
Both the motor/transmission and controller are very heavy! Be careful while removing
the products from packaging to avoid dropping the components and potentially
damaging the products.
Section 2.1
WARNING
Do not modify, or cut and re-solder, the Signal cable length. If you need an alternate
length, contact Danfoss Power Solutions.
WARNING
Do not modify, or cut and re-solder, the Phase cable length. If you need an alternate
length, contact Danfoss Power Solutions.
Summary of Contents for ED-DT318B
Page 185: ......
