15
m
m
(0
.5
9
In
ch
)
1
2
3
4
5
6
7
cc-0048
1
2
3
4
5
6
7
Tightening torque 15 Nm
HM 8 bolt (4 pcs)
Lock washer (4 pcs)
Flat washer (4 pcs)
Steel mounting sleeve (4 pcs)
Rubber grommet (4 pcs)
Nut (4 pcs)
Figure 25: Rubber grommets from kit 8156138
1
CC
-0
00
00
01
Figure 26: Rubber grommets
27
.5
m
m
(1
.0
8
in
ch
)
CC-0049
2
8
3
4
5
6
7
1
2
3
4
5
6
7
8
Single requirements DSH090-105-120-140-161-184 mounting
Compressors DSH090-105-120-140-161-184 are delivered with rubber grommets and steel mounting sleeve used to
isolated the compressor from the base frame.
The grommets must be compressed until contact between the flat washer and the steel mounting sleeve is
established. The required bolt size for the DSH090-105-120-140-161-184 compressors is HM8-40. This bolt must be
tightened to a torque of 15Nm.
Figure 24: Rubber grommets
Part 2, 3, 4, 5, 6 and 7 are delivered along with
compressor
Single requirements DSH240-295-381-485 -600 mounting
To be used in single applications, an additional accessory including flexible grommets is necessary kit 8156138.
The grommets must be compressed until contact between the flat washer and the steel mounting sleeve is
established. The required bolt size for the DSH240-295-381-485-600 compressors is HM8-55. This bolt must be
tightened to a torque of 21Nm.
Rubber grommets from kit 8156138
HM 8 bolt (4 pcs)
Lock washer (4 pcs)
Flat washer (4 pcs)
Steel mounting sleeve (4 pcs)
Rubber grommet (4 pcs)
Nut (4 pcs)
Compressor base plate
© Danfoss | Climate Solutions | 2022.10
AB288965961751en-001402 | 27
Scroll compressors, DSH090 to DSH600 | Mechanical connections