Installation and User Guide
DEVIreg™ Multi
FEC | Produced by Danfoss ©
23
Parameters setting for
PR
mode can be done by the following menu sequence:
EN: Main Screen – Enter to Main Menu – Channels settings – Channel #X – On Time
& Period – { Enter – #X Set On Time – Down – #X Set PR Period }
EN: Main Screen – Enter to Main Menu – Channels settings – Channel #X – On Time
& Period – { Enter – #X Set On Time – Down – #X Set PR Period }
Line of the
Main screen
with
PR
mode data for one
Channel
is shown on the picture below:
Time from
the beginning
of the
Period
(min.)
Heating status:
On
or
Of
On Time
(min.)
Period
(min.)
4.4.5
MOn and MOf – Manually heating On and Manually heating Of mode
Manually On/Of
mode (on the screen –
MOn
or
MOf
) is control with setting time period
during which heating will be turned on or turned off . This mode can be started only on
the base of
1S
or
PR
mode and after
Manually On/Of
mode is finished, controller returns
to the same initial mode –
1S
or
PR
.
This mode can be individually set up for any
Channel
.
Three control parameters can be set up: time period, heating state –
On
or
Of
,
and
Start
or
Stop
mode state .
Time Period
. Setting Period of time for
MOn
or
MOf
mode . Default – 1 min .
Heating status
. Setting state
Heating On
or
Heating Of
. Default –
Of
.
Start or Stop
. Starting or Stopping control mode . After finishing of
MOn
or
MOf
mode
controller goes to
Stop
state automatically and disappears from the screen automatically
too . Default –
Stop
.
NB: It is the full responsibility of the installer/user to use this mode and to set up correct states that
correspond to the specific application to avoid overheating of the cable, building materials and so on.
