Software
Sirius digital Mixer from D&R Phone +31 294 418014, email:
Page 35
7.2.12 Remote
This field is only active (visible) when an analog output unit is connected in the system. An
indication of what all remote functions are is shown. These functions are already pre -
programmed in the analog output unit.
7.2.13 Output mute controlled by
The selected output could be a speaker that needed to be muted when a microphone is
activated. The Sirius has three mute busses for this functionality. A CRM, Studio 1 and Studio
2 mute buss. Here you can decide which mute buss should respond.
7.2.14 Digital to digital output set-up
In the upper right hand corner you see selections that can be
made specific for user definable output units.
Below are the specific options for the stereo digital output box.
You can select which data format all outgoing data should have.
This could be professional (AES/EBU) or consumer (Coax and
Optical). When you have selected pro status Copy-bit and
Original are not active anymore.
In the consumer mode you have the option of activating Copy-
bit and Original.
Then you also have the possibility to activate dither on the output.
The next option is ‘Use input clock’. If activated you can insert the sample rate converter
between internal output and external output. The external output is “clocked” according to the
clock frequency found on the corresponding digital input.
NOTE: When this option is activated it is not possible to use audio data of the digital input.
The final option is “Swap L/R”. Left and right channels are swapped before hooked up to the
outputs.
7.2.15 Digital to analog output set-up
Another possible output option set-up is now described for the
Mono Analog Output unit. See Drawing.
You have the possibility to trim the output level to interface with
the correct level to external analog equipment. This is a global
setting that needs to be done carefully to work with correct
levels!
