Rigging/derigging
4. Add further cabinets
1. Extend the Front links of the first cabinet.
2. At the rear of the second cabinet, release the Locking pin of
the Splay link.
3. Fold out the Splay link.
4. Set the link to the required length (Standard or Extended) and
turn the extension tube head counter clockwise by 90°.
5. Align the Front links of the second cabinet with the
corresponding slots of the first cabinet, as shown in the
graphic opposite.
6. Insert the Front links into the slots and slightly pull the second
cabinet to the front until the links have engaged.
7. Fold the cabinet towards the back.
5. Set the splay angle
The splay angles between adjacent cabinets are set on the central
rear rigging strands of the cabinets and can be set in the range
from 20° to 40° in 5° increments.
Select the splay angles according to your ArrayCalc simulation.
Depending on the desired splay angle, set the extension tube to
the "Standard" or the "Extended" length as described in
Chapter 2.3.3 "Setting the splay angle(s)" on page 8.
1. Align the Splay link of the first cabinet with the corresponding
hole for the desired splay angle on the rear rigging strand of
the second cabinet.
2. Insert the respective Locking pin and ensure the pin is fully
inserted and properly locked.
To add a third cabinet, proceed in the same manner until the
assembly is completed.
d&b Z5458
AL Base plate Rigging manual 1.1 en
12