KSLi arrays and assembly procedures
8. Splay link of the last cabinet
To avoid either rattling during operation or damage to the Splay
link of the last cabinet, we recommend you to remove the link and
store it in a safe place. To remove the link, proceed as follows:
1. Release and remove the ring cotter
[1] of the fixing bolt.
2. Remove the fixing bolt
[2] and the link [3].
3. To avoid losing any item, reattach the fixing bolt to the link
and refit the ring cotter.
9. Check the assembly
Before hoisting the array to its operating position, recheck the
actual status of the entire assembly according to the checklist given
Chapter 4 "Safety and system checks/Hoisting" on page 28.
10. Rig the cabling
Connect the cables and link cables according to the number of
amplifier channels and cabinets used.
▪ If the amplifiers are already wired and powered on, use their
System check functions or channel mute switches and a test
signal to check the correct operation and routing of all channels
and cabinets.
▪ Alternatively, check the wiring using the Array verification
function in R1.
d&b KSLi Rigging manual 1.1 en
27
