d&b audiotechnik 10D, Manual, Page: 74 / 92

13.8.3. LINEAR setup
In addition to the loudspeaker specific setups, a LINEAR setup is
also available allowing the 10D/30D to be used as a linear
power amplifier.
Note: CUT in LINEAR setup:
▪ Butterworth 2nd order (12 dB/oct.)
▪ Corner frequency: 110 Hz
▪ Amplifier gain @ 0 dB: 31 dB.
13.9. Channel linking
Selecting «Channel linking» opens the corresponding subscreen.
Provided the amplifier's output mode is set to Dual Channel and/or
Mix TOP/SUB mode, the «Channel linking» function allows either
channel EQ and/or Delay settings to be linked.
There are four direction modes:
▪ A
Þ
B
▪ A
Þ
BC
▪ A
Þ
BCD
▪ C
Þ
D
The linked functions can then be controlled from the «Channel»
menu of channel A and/or C, while these functions are disabled in
the «Channel» menus of channels B and D.
When choosing either «A
Þ
BC» or «A
Þ
BCD», the «Link C»
function is disabled (set to «Off»).
However, when activating «Link C» while «Link A» is set as
described above, the «Link A» function is disabled
correspondingly.
In the «Channel» menu, this status is indicated by a horizontal eight
(«
¥
»), as shown in the graphic opposite.
The On/Off status of the link function is indicated in the respective
channel menu, as shown in the graphic opposite.
Channel linking example: EQ A
Þ
B; EQ and Delay C
Þ
D
d&b 10D/30D Manual 1.10 en 74