Dancover TITAN Arch 280, Manual

Page: 9 / 30

NOTE: POLYCARBONATE SHEETS ARE LAID WITH UV
PROCESSED SIDE TO THE SUN (THE PROTECTIVE TAPE WITH AN
INSCRIPTION OUTSIDE). IT IS IMPORTANT TO REMOVE
POLYCARBONATE PROTECTIVE TAPES FROM BOTH SIDES PRIOR
TO INSTALLATION ON THE CARCASS. IT IS IMPORTANT NOT TO
MIX WHICH SIDE IS PROCESSED WITH UV PROTECTIVE LAYER.
VIEW FIGURE 13-14.
11. Put on an aluminum foil (19) on the open ends of the channel-
polycarbonate on the top of side sheet of polycarbonate and only after it put on the
top polycarbonate part (10 – 2100x6000 mm).
VIEW FIGURE 15.
12. Upper-solid polycarbonate sheets -10- place from a bottom to the top,
starting from one side. The polycarbonate is fixed with screws M5-40 (13), screws
(15) and interims (16). One arch band has 4 (four) marked fixation points. Please
fix EXACTLY only at designated fixation points. The other side has to be fixed
from the top to bottom at designated and marked 4 (four) fixation points. If the
solid sheet of the polycarbonate is too long, cut it so it would equally touch the
bottom of reinforcement between the side arches (NR. 11). The next top-solid -10-
polycarbonate sheet change on already attached sheet and tighten in the same
principle ONLY at designated areas. At the front and at the end polycarbonate
sheets has to protrude for 5-7 cm.
NOTE: POLYCARBONATE SHEETS ARE LAID WITH UV
PROCESSED SIDE TO THE SUN (THE PROTECTIVE TAPE WITH AN
INSCRIPTION OUTSIDE). IT IS IMPORTANT TO REMOVE
POLYCARBONATE PROTECTIVE TAPES FROM BOTH SIDES PRIOR
TO INSTALLATION ON THE CARCASS. IT IS IMPORTANT NOT TO
MIX WHICH SIDE IS PROCESSED WITH UV PROTECTIVE LAYER.
VIEW FIGURE 16.
13. Assembly of doors-windows. All the parts presented in set of doors part
connect into a square (DOORS NR. 1, DOORS NR. 2, DOORS NR. 3) by screws
M5-12 (12) and screws M5 (15).
VIEW FIGURE 17.
14.
Part of the doors with loops (DOORS NR. 2) screw on to doors-windows
stand (NR. 8) with screws M5-12 (12) and screws M5 (15) (Fig. 23).
NOTE: Doors are attached to doors stands when doors are fully opened
and loop stretched out into the outside of a hole, through the canal
polycarbonate.
VIEW FIGURE 18.
15.
According to the polycarbonate cutting scheme cut the polycarbonate (-5-
; -6-; -7-). Cut polycarbonate parts of the window of doors put on ONLY when
loops of doors are fixed to the carcass. Polycarbonate sheets of doors-window are
fixed to the frame of doors-window with screws M5-40 (13) and screws M5 (15)
and interims (16). The upper ends of the polycarbonate of doors-window seal
with a protective sheet tape (19). Connect handles (17) already at the prepared
doors-window areas.
VIEW FIGURE 19.