Dancover TITAN Arch 280, Manual

Page: 7 / 30

Installation procedure:
1. Assembly of front and rear parts of a greenhouse. Assembly of arches. The
most convenient way to assemble front and rear arch by laying them on the
ground. Attach fixtures to the ground (NR.4) to the lower parts of side lower arch
stands (NR. 3), and to the top parts – side arches (NR. 2) from both sides, and on
the top in the middle section to side arches – short top arch (NR. 1) with screws
M5-12 (12) and screws (15).
VIEW FIGURE 1
2.
With screws M5-12 (12) and screws (15) attach fixation angles of stands
(18) to the assembled arches. VIEW FIGURE 2
3. To the overhead fixation angles of stands (18) screw on doors-windows
stand (NR. 8) with screws M5-12 (12) and screws (15). To the lower parts of
windows stands of the bottom door (NR. 8) screw on fixtures to the ground (NR.4)
with screws M5-12 (12) and screws (15).
VIEW FIGURE 3
4. Assembly of the front part of a greenhouse. Screw on doors-windows
transverse stands (NR. 8) with screws M5-12 (12) and screws (15) between doors-
windows stand (NR. 8). At the sides of doors-windows stand (NR. 8) screw on
side reinforcements of the front-rear part (NR. 9) and reinforcements at the
bottom of sides (NR. 5) with screws M5-12 (12) and screws (15).
NOTE. The lower doors-windows transverse stand (NR. 8) is fixed one
hole below than fixtures at the bottom of sides and holds only one screw M5-
12 and screw (15). VIEW FIGURE 4
To the arch according to the provided drawing (5) fix reinforcement of arches –
stands (NR.6) and reinforcement between side arches at the bottom (NR. 11) with
screws M5-12 (12) and screws (15).
VIEW FIGURE 5
Starting from the bottom, fix the second arch to reinforcement of side arches
(NR. 11) and reinforcement of arches – crossbars (NR. 6) with screws M5-12 (12)
and screws (15), which can be assembled by parts, screwing to the current frame,
or by screwing in advance assembled arch (sequence in paragraph Nr. 1). The
assembled fragment from two arches with fixtures raise from the ground and put
up vertically.
VIEW FIGURE 6
5. Assembly of the rear part of a greenhouse. Screw on transverse stand of
doors-windows (NR. 10) with screws M5-12 (12) and screws (15) between doors-
windows stand (NR. 8). At the sides of doors-windows stands (NR. 8) screw on
with screws M5-12 (12) and screws (15) side reinforcements of the front-rear part
(NR. 9) and reinforcements at the bottom of sides (NR. 5).
VIEW FIGURE 7.
To the arch according to the presented drawing (5) screw on with screws M5-
12 (12) and screws (15) reinforcements of arches – crossbars (NR. 6) and
reinforcements between side arches at the bottom (NR. 11). VIEW FIGURE 8.