CLEANING/MAINTENANCE/STORAGE
CLEANING AND MAINTENANCE:
To enjoy outstanding performance of your heater for years make sure to perform the following
maintenance activities on a regular basis:
●
Keep exterior surfaces clean.
-Use warm soapy water for cleaning. Never use flammable, corrosive or abrasive cleaners.
-While washing your unit, be sure to keep the area around the burner and pilot assembly dry at
all times. If the gas control is exposed to water in any way, do NOT try to use it. It must be
replaced.
●
After a long break from operation, the unit should be inspected for spiders, spider webs or
other insects.
●
Air flow must be unobstructed. Keep controls. Burner and circulating air passageways clean.
Signs of possible blockage include:
-Gas odour with extreme yellow tip to the flame.
-Heater does NOT reach the desired temperature.
-Heater glow is excessively uneven.
-Heater makes popping noises.
●
Spider and insects can nest in burner or orifices.
This dangerous condition can damage heater and render it unsafe for use. Clean burner holes by
using a heavy-duty pipe cleaner.
Compressed air may help clear away smaller particles.
●
Carbon deposits may create a fire hazard. Clean reflector and glass tube inside with soapy
water if any carbon deposits develop. Always be careful when cleaning the glass tube.
STORAGE:
Between uses:
●
Turn the control knob to “ OFF ” position.
●
Turn LPG cylinder to “OFF” position.
●
Store heater upright in an area sheltered away from weather (such as rain, sleet, hail, snow).
●
If possible, cover the heater to protect exterior surfaces and to help prevent dust and debris
collecting in air passages.
During periods of extended inactivity or when transporting:
●
Turn the control knob to “ OFF ” position.
●
Disconnect LPG Cylinder and move to a secure, well-ventilated location outdoors.
DO NOT store in a location that will exceed 50 degrees C.
WARNING
FOR YOUR SAFETY:
●
DO NOT touch or move heater for at
Least 45 minutes after use.
●
Allow all burner elements to cool
before Touching.
NOTE
●
In a salt-air environment (such as
near an Ocean) corrosion occurs
more quickly than normal.
●
Frequently check for corroded areas
and Repair them promptly.
●
Wait until heater is cool before
covering.
10
