Dancover ARROW 2,6, Manual

Page: 11 / 29

10
2
2
2
2
2
2
2
2
2
2
2
2
Assembly arches 4в pairwise by joining them
to each other with the ridge strap and brace
9 . Join butt end parts 5 with the support hook
to arches 4в.
Join beams 2 to
assembled arches.
2
2
4в
Assembly stages
Pic. 5
Pic. 6
Level the frame by adding some soil into the holes or deepening the holes in order to make
sure that the lateral parts are straight, horizontal and parallel to each other, and that the
arches are straight when seen from aside. If it is necessary to adjust arches, loosen the
joints between beams and arches, level the frame on the ground and tighten the screws
again. Put soil on the stands of the frame after fixing lower wire bindings on part 3 (Piс.10)
Perform the assembly next to the installation site of the greenhouse.
Perform the assembly in accordance with the pictures of assembly stages and the joints
as shown in Pic. 5...12. The pictures illustrate assembly of a 4 m long greenhouse. The
required length of a greenhouse is attained by adding corresponding parts from Inset
package(s). To join the parts, screws М5х10 are used.
On the site selected for installation of the greenhouse, dig holes as shown by the scheme in
Pic. 4 to the spade length depth. Set the frame into the holes. Use the line to check that the
diagonals of the frame are equal. General settlement of the greenhouse on the ground is
made in such a way that the lower parts 6 of the door opening touch the ground, and parts
2 are some 5 cm above the ground. Use the line again to check the diagonals so that they
are equal and adjust the corners of the frame if necessary.
1.
2.
3.
4.
Installation steps
4в
5
Support hook
Manual
4в
4в
4в
4в
4в
4в
4в
4в
4в
4в
5
5
9
9
9
А
В
Б
Ridge strap
4в
Б
4в
9
А Б
В