1
Ropelight Connector
This manual describes how to connect two sections of rope
light together.
Important overall safety announcements for rope light
-
Make sure the rope light is used in open areas where air is ventilated and heat can escape to ensure rope light does
not overheat.
-
Switch off the rope light 2-3 minutes before taking steps to apply a connector and uncoil the rope.
-
Do not bend the rope light continuously – always keep rope light straight when possible
-
Do not submerge the rope light in water
-
Do not put the rope light in a damp area unless joints have been sealed with silicon glue
-
Do not cut and connect rope light outdoor without ensuring protection from getting wet.
-
To prevent a possible risk of fire or electric shock, DO NOT cut or damage outer PVC tubing, pulls on or stretch rope
light as this will damage the inner wires.
-
Don’t plug it before installation
Rope light is waterproof but when used outdoors in an area that is damp or could get wet, make sure to seal all
connections with silicone or silicone tape and never submerge in water.
Connector is not waterproof.
When using ropelight outdoors which has connector you must seal connector with silicon glue or similar.
1.
Where do I cut rope light?
Rope light can be cut Every 1 Meter (at marked intervals). There is a cutting mark on the rope indicating where to
cut. Be very careful to cut cleanly and only where indicated. If you cut elsewhere, it will ruin that stretch of light and
cause it to fade and not work.