自攻螺丝
12
Set and Adjust
设置和调试
常规飞行(Normal Flying)
3D飞行 部分飞机支持(
Aerobatic flying, not recommended for this model
)
副翼 Aileron ±（15°-30°） ±40° 或者更大(or larger)
平尾 Elevator ±15°
±40° 或者更大(or larger)
垂尾 Rudder ±15°
±40° 或者更大(or larger)
常用襟翼 Flap （起飞 take-off）15°-20° （降落 Landing）20°-40°
6
部分特殊机型会有V型尾翼，襟翼，前缘机翼或舵面很小等，可以以常规飞行的角度作为参考，在您不确认且没有有经验人员指导
的情况下，我们建议您先以小角度试飞以确认您的设置是否正确。
The above control deflections are for reference only. If you are inexperienced we recommend small deflections and
also that you enlist the help of an experienced RC pilot. The leading edge slats if being used will need to be
experimented with to obtain the optimum settings for slow flight.
Rudder
Elevator
Aileron
20°-35°
25°
25°
25°
25°
20°-35°
通常情况下，舵面角度的设置如下
Suggested control throws
:
≈70-75mm
重心位置展示
C.G
Position
self-tapping screws
升降舵
副翼
方向舵
C.G
≈70-75mm
当前缘缝翼 Leading Edge Slat 紧贴机翼时 速度保持不变 升力保持不变。
当打开一定角度的前缘缝翼时，速度减慢，升力提升。（注意不要设置开启角度过大，当角
度太大时，速度过慢，升力会减小。）
When the leading edge slat is close to the wing, the speed remains the same and
the lift remains the same.
When the leading edge slat is opened
to
a certain angle, the speed decreases and
the lift increases. Be careful not to set the opening angle too large.
If you do
the
speed will
very quickly drop off and the plane will get
too slow
,
the lift will
then
decrease
causing the wing to stall.
前缘缝翼
Leading Edge Slat
蒙皮详细操作可查看以下链接内容，我们提供了蒙
皮范本（可直接扫二维码）
For detailed
instructions
of
covering the model with film
please view the
following link
below
.
You can also sc
an scan the QR code
.
http://www.dwhobby.com/art/film
完成以上拼装后即可对飞机进行蒙皮
For initial flights we recommend you
balance the model on the 70mm mark to
make it more docile. Once you have
flown it a few times you can then move it
back slightly if you wish, this will make
the flying characteristics more agile
.
